Rainbow Electronics 900 - Manual (Page 120)

FLYFOT-M260-MODULE
Page: 120 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
13 GPRS commands
GPRS commands are not available under GSM-only software.
13.1 Define PDP Context +CGDCONT
13.1.1 Description
This command specifies PDP context parameter values for a PDP context identified by the local context
identification parameter, .
Three PDP contexts can be defined through FLYFOT software.
A special form of the set command, +CGDCONT= causes the values for context number to
become undefined.
The test command returns values supported as a compound value. If the MT supports several PDP types,
, the parameter value ranges for each are returned on a separate line.
The read command returns the current settings for each defined context.
13.1.2 Syntax
Command Possible response(s)
AT+CGDCONT=[ [, [,
[, [, [,]]]]]]
Note: set PDP OK
Note: set successfully
+CME ERROR: 3
Note: set failed
AT+CGDCONT?
Note: get all PDPs information +CGDCONT: , ,
,, ,
[+CGDCONT: , ,
,, ,
[...]]
OK
Note: succeed
AT+CGDCONT=? +CGDCONT: (range of supported s),
,,,(list of supported s),
(list of supported s)
[+CGDCONT: (range of supported
s),
,,,(list of supported s),(list of
supported s)
[...]]
OK
Note: get parameter range