Rainbow Electronics 900 - Manual (Page 187)

FLYFOT-M260-MODULE
Page: 187 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
0 : Controller 1 (Default)
1 : Controller 2
18.19 FLYFOT Status Request +WSTR
18.19.1 Description :
This specific command returns some operation status. It can be used for example to check the state of
the initialisation sequence; the different values returned are Not started, Ongoing, Finished.
18.19.2 Syntax :
Command syntax: AT+WSTR=
Response syntax: +WSTR: ,
Command Possible responses
AT+WSTR= +WSTR :,
AT+WSTR=1 +WSTR: 1,2
Note : Select the status 1 (INIT SEQUENCE) OK
Note : Init finished
AT+WSTR=2 +WSTR: 2,1
Note : Select the status 2 (NETWORK OK
STATUS) Note : The network is available
AT+WSTR=? +WSTR: (1-2)
Note : Ask for the list of possible values
Note : possible values : 1 and 2
18.19.3 Defined values
1 : Initialisation sequence
0 : Not started
1 : On going
2 : Finished
2 : Network status
0 : No network
1 : Network available