Rainbow Electronics 900 - Manual (Page 211)

FLYFOT-M260-MODULE
Page: 211 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
18.39.3 Defined values
0 : Set active line
1 : Get active line
:
Only used for = 0
1 : Line 1
2 : Line 2
18.40 FLYFOT Open AT control command +WOPEN
18.40.1 Description
This specific command allows to start, stop, delete and get information about the current Open AT
embedded application.
Note :This command is only available if the Open AT feature is enabled (cf +WCFM command).
18.40.2 Syntax
Command syntax AT+WOPEN=
Response syntax +WOPEN: [,[]]
Command Possible responses
AT+WOPEN=? +WOPEN: (0-4)
OK
AT+WOPEN? +WOPEN: 0
OK
AT+WOPEN=2 +WOPEN: 2, “AT v2.00”, “AT v2.00”
Note : Get the Open-AT library OK
versions. Note : Open-AT v2.00 library version. An
embedded application has been
downloaded on this product.
AT+WOPEN=3 OK
Note : The objects flash are erased
AT+WOPEN=1 OK
Note : Start the embedded application. +WIND: 3
Note : Product reset in order to start the
embedded application.
AT+WOPEN = 3 +CME ERROR: 532