Rainbow Electronics 900 - Manual (Page 234)

FLYFOT-M260-MODULE
Page: 234 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
Cause value Diagnostic
224 MS requested detach
225 PDP unsuccessful activation cause MMI ignore
226 NWK requested Detach
227 Unsuccessful attach cause NO SERVICE
228 Unsuccessful attach cause NO ACCESS
229 Unsuccessful attach cause GPRS SERVICE REFUSED
230 PDP deactivation requested by Nwk
231 PDP deactivation cause LLC link activation failed
232 PDP deactivation cause NWK reactivation with same TI
233 PDP deactivation cause GMM abort
234 PDP deactivation cause LLC or SNDCP failure
235 PDP unsuccessful activation cause GMM error
236 PDP unsuccessful activation cause NWK reject
237 PDP unsuccessful activation cause NO NSAPI available
238 PDP unsuccessful activation cause SM refuse
All other values in the range 0 to 31 shall be treated as cause 31.
All other values in the range 32 to 47 shall be treated as cause 47.
All other values in the range 48 to 63 shall be treated as cause 63.
All other values in the range 64 to 79 shall be treated as cause 79.
All other values in the range 80 to 95 shall be treated as cause 95.
All other values in the range 96 to 111 shall be treated as cause 111.
All other values in the range 112 to 127 shall be treated as cause 127.
19.5 Specific Failure Cause for +CEER
Cause value Diagnostic
240 FDN is active and number is not in FDN
241 Call operation not allowed
252 Call barring on outgoing calls
253 Call barring on incoming calls
254 Call impossible
255 Lower layer failure
19.6 GSM 04.11 Annex E-2: Mobile originating SM-transfer
These error causes could appear for SMS commands (+CMGS, +CMSS,
+CMGD…)
Cause no 1: "Unassigned (unallocated) number"
This cause indicates that the destination requested by the Mobile Station cannot be reached
because, although the number is in a valid format, it is not currently assigned (allocated).