2 syntax, 3 defined values, 22 control flash led command +tfled – Rainbow Electronics 900 User Manual
Page 24: 1 description, 22 control, Flash, Command +tfled

FLYFOT-M260-MODULE
Page: 24 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
4.21.2 Syntax
:
Command syntax : AT+TMEL=
Command
Possible responses
AT+TMEL=2,3
Note: Set the alert type and volume
OK
AT+TMEL =?
Note: Get possible value
+TMEL: (0-15),(1-3)
OK
AT+TMEL =10,4
Note: Set invalid value
+CME ERROR: 3
Note: The product can not support this command
AT+ TMEL?
AT+ TMEL
+CME ERROR: 3
Note: The product can not support this command
4.21.3 Defined
values
:
0: none alert tone
(1-15): different alert tone
1: The volume is lowest
2: The volume is middle
3: The volume is topmost
4.22 Control Flash LED Command +TFLED
4.22.1 Description
This command with six parameters is used to control the flash led sparking.
4.22.2 Syntax
AT+TFLED=[Operation],
Command
Possible responses
AT+ TFLED =?
Note: Set the alert type and volume
+TFLED:
(0-1),(0-65535),(0-65535),(0-65535),(0-65535),(0-1)
OK
AT+ TFLED =1,10,10,10,10 ,1
Note: Get possible value
OK
AT+ TFLED =10,4
Note: Set invalid value
+CME ERROR: 3
Note: The product can not support this command
AT+ TFLED?
+TFLED: 1,10,10,10,10,1
AT+ TFLED
+CME ERROR: 3
Note: The product can not support this command