Rainbow Electronics 900 - Manual (Page 159)

FLYFOT-M260-MODULE
Page: 159 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
Command Possible responses
AT+CRC=0
Note : Extended reports disabled OK
Note : Command valid
AT+CRC=1
Note : Extended reports enabled OK
Note : Command valid
AT+CRC?
+CRC: 1
OK
AT+CRC=?
+CRC: (0,1)
OK
16.4.3 Defined values:
:
0: disable extended reports
1: enable extended reports
16.5 DTE-DCE local rate reporting +ILRR
16.5.1 Description :
This parameter controls whether the extended-format “+ILRR:” information text is transmitted from
the DCE to the DTE or not. The value reported represents the current (negotiated or renegotiated)
DTE-DCE speed rate.
If enabled, the intermediate result code is transmitted in an incoming or outgoing data call, after any data
compression report, and before any final result code (CONNECT).
16.5.2 Syntax :
Command syntax : AT+ILRR =
Command
Possible responses
AT+ILRR=0
Note : Local port rate report disabled OK
Note : Command valid
AT+ILRR=1
Note : Local port rate report enabled OK
Note : Command valid
AT+ILRR?
+ILRR: 1
OK
AT+ILRR=?
+ILRR: (0,1)
OK
16.5.3 Defined values:
:
0: disable local port rate report
1: enable local port rate report