Rainbow Electronics 900 - Manual (Page 125)

FLYFOT-M260-MODULE
Page: 125 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
z 2 : not registered, but ME is currently searching a new operator to register to
z 3 : registration denied
z 4 : unknown
z 5 : registered, roaming
:
string type; two byte location area code in hexadecimal format.
:
string type; two byte cell ID in hexadecimal format
13.5 Quality of Service Profile (Requested) +CGQREQ
13.5.1 Description
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an
Activate PDP Context Request message to the network.
The set command specifies a profile for the context identified by the local context identification
parameter, . Since this is the same parameter that is used in the +CGDCONT command, the
+CGQREQ command is effectively an extension to the +CGDCONT command. The QoS profile consists
of a number of parameters, each of which may be set to a separate value.
A special form of the set command, +CGQREQ= causes the requested profile for context
number to become undefined.
The read command returns the current settings for each defined context. The test command returns values
supported as a compound value. If the MT supports several PDP types, the parameter value ranges for each
PDP type are returned on a separate line.
13.5.2 Syntax
Command Possible Response(s)
AT+CGQREQ=[ [, OK
[, [, [, ERROR
[,]]]]]]
AT+CGQREQ? +CGQREQ: , , ,
, ,
[+CGQREQ: , ,
, , , […]]
OK
AT+CGQREQ=? +CGQREQ: , (list of supported