Rainbow Electronics AT75C310 - Manual (Page 79)

AT75C310
79
Signal Name Description
Note: After a hardware reset, the timer/counter block pins are
controlled by the PIO controller. They must be configured
to be controlled by the peripheral before being used.
Timer/Counter Description
The three timer/counter channels are independent and
identical in operation. The registers for channel program-
ming are listed in Table 19 on page 85.
Counter
Each timer/counter channel is organized around a 16-bit
counter. The value of the counter is incremented at each
positive edge of the selected clock. When the counter has
reached the value 0xFFFF and passes to 0x0000, an over-
flow occurs and the bit COVFS in TC_SR (Status Register)
is set.
The current value of the counter is accessible in real time
by reading TC_CV. The counter can be reset by a trigger.
In this case, the counter value passes to 0x0000 on the
next valid edge of the selected clock.
Clock Selection
At block level, input clock signals of each channel can
either be connected to the external inputs TCLK0, TCLK1
or TCLK2 or be connected to the configurable I/O signals
TIOA0, TIOA1 or TIOA2 for chaining by programming the
TC_BMR (Block Mode).
Each channel can independently select an internal or exter-
nal clock source for its counter:
• Internal clock signals: ACLK/2, ACLK/8, ACLK/32,
ACLK/128, ACLK/1024
• External clock signals: XC0, XC1 or XC2
The selected clock can be inverted with the CLKI bit in
TC_CMR (Channel Mode). This allows counting on the
opposite edges of the clock.
The burst function allows the clock to be validated when an
external signal is high. The BURST parameter in the Mode
Register defines this signal (none, XC0, XC1, XC2).
Note: In all cases, if an external clock is used, the duration of
each of its levels must be longer than the system clock
(ACLK) period. The external clock frequency must be at
least 2.5 times lower than the system clock (ACLK).
Channel Signal Description
XC0, XC1, XC2 External Clock Inputs
TIOA Capture Mode: General-purpose input
Waveform Mode: General-purpose output
TIOB Capture Mode: General-purpose input
Waveform Mode: General-purpose input/output
INT Interrupt signal output
SYNC Synchronization input signal
Block Signal
TCLK0, TCLK1, TCLK2 External Clock Inputs
TIOA0 TIOA signal for Channel 0
TIOB0 TIOB signal for Channel 0
TIOA1 TIOA signal for Channel 1
TIOB1 TIOB signal for Channel 1
TIOA2 TIOA signal for Channel 2
TIOB2 TIOB signal for Channel 2