Graphics spd up, Page format, Reset cmd cfg ld – Printronix P7000 H-Series Cartridge Ribbon Printer User Manual
Page 99
Hangul LP+ Emulation
99
Taller 15 CPI
This parameter allows you to specify the appearance of ASCII characters as
15 CPI in ASCII mode.
•
Disable
(default). The characters in 15 CPI appear shorter than other
CPIs such as 10 CPI.
•
Enable
. The height of 15 CPI characters is the same as other CPIs such
as 10 CPI.
Horizontal Expnd
This parameter allows you to specify dot character horizontal expansion for
both ASCII and DBCS characters in DBCS mode.
Vertical Expnd
This parameter allows you to specify dot character vertical expansion for both
ASCII and DBCS characters in DBCS mode.
Graphics Spd Up
This menu is used to increase (speed up) graphic printing speed by turning on
the Enhanced/Turbo mode.
•
Normal
(the default). The printer prints at the given input graphics
resolution.
•
Enhanced
. The printer provides first-level speed up, which means the
speed is faster than Normal mode.
•
Turbo
. The printer provides second-level speed up, which means the
speed is faster than Enhanced mode.
•
Match Typeface
. The input 180x180 dpi graphics resolution will drop-dot
to the resolution which matches the typeface selected.
Page Format
Reset Cmd CFG Ld
When the printer receives a host data stream reset command (ESC @) in
addition to resetting printer variables, the power-up configuration will be
loaded.
•
Disable
(the default). The active emulation parameters are loaded when
the reset command is executed.
•
Power-Up Config
. The power-up configuration is loaded when the reset
command is executed.
•
Current Config
. The currently selected configuration is loaded when the
reset command is executed.
•
Factory Config
. The factory installed configuration is loaded when the
reset command is executed.