Printronix P7000 H-Series Cartridge Ribbon Printer - Manual (Page 88)

88
Chapter 4 NETWORK SETUP MENU
Auth Method
This feature allows the user to select the authentication method used for the
wireless network interface.
• Open (the default). Selects open authentication.
• Shared . Selects shared key authentication.
• Kerberos . Selects Kerberos authentication (for use when a Symbol RF
card is installed).
• LEAP . Selects LEAP authentication (for use with a Cisco RF card
installed).
WEP Key 1 Through WEP Key 4
• WEP Key Format . Allows you to format the WEP keys in ASCII or
hexadecimal code. The default is hexadecimal.
• WEP Key Width . This is the encryption strength. The options are 40 Bits
and 128 Bits; 40 Bits are weaker and 128 Bits are stronger.
NOTE: If you select 40 Bits, the WEP key BYTE6 through WEP Key BYTE13
menus will not display.
The default is 128 Bits.
• WEP Key BYTE1 through BYTE13 . These are the individual characters
of the encryption key.
Default WEP Key
This feature enables you to encrypt (scramble) information for security
purposes. With this feature, you can set up to four encryption keys, in either
ASCII or hexadecimal format, and in either 40 or 128 bits. (The more bits you
choose, the more difficult it will be to decode the information.)
NOTE: None of the WEP Key Configuration menus display on the
configuration printout.
Reset WEP Keys
Allows you to reset all four WEP keys (WEP Key 1 through WEP Key 4) at
one time.
WPA Mode
Selects the WPA wireless security mode.
• Disable (the default). WPA security is disabled.
• Personal . Selects personal or pre-shared key mode for WPA security.