Printronix P7000 H-Series Cartridge Ribbon Printer - Manual (Page 96)

96
Chapter 4 EMULATION
CPI/LPI Select
This parameter lets you specify the characters per inch (cpi) and lines per
inch (lpi) values. The defaults are 10 cpi, 6 lpi, and 6.7 cpi for the Hanzi LP+
printer. For the Hangul LP+ printer, the default is 6 cpi and 6 lpi. For the Kanji
LP+ printer, the default is 15 cpi, 8 lpi, and 7.5 cpi.
Host Command
• Enable . Enables all host printing commands.
• Ignore All . This function ignores all host commands.
• Ignore CPI . This function ignores the CPI selection commands only (e.g.,
ESC M, ESC P, and ESC g).
• Ignore LPI . This function ignores the LPI selection commands only (e.g,
ESC 2 and ESC 0).
• Ignore Unidirectional (the default). All unidirectional commands sent by
the host are ignored by the printer.
• Ignore Pg. Fmt . All page format commands sent by the host are ignored
by the printer. This is applicable only for Hangul LP+ printers only.
Font Attributes
Typeface
This parameter allows you to select the typeface for printing in the emulation.
• LQ . Default value for Hanzi Big5/Hangul.
• Near LQ . Default value for Hanzi GB/Kanji printer.
• Normal .
• Hi-Speed
• Super Hi-Speed
• Ultra Hi-Speed
Styling Typeface
• SONG . Only for Hanzi GB printer.
• MING . Only for Hanzi Big5 printer.
• Mincho . Only for Kanji printer.
• Myungjo, Gothic . Only for Hangul printer. Myungjo is the default value.
High Density
• Disable (default)
• Enable . Allows the LQ typeface to print in higher print density, and it will
not take effect when other typefaces are selected.