Printronix P7000 H-Series Cartridge Ribbon Printer User Manual
Page 31
Reload Paper
31
24.
Pedestal models
:
Using the vertical position knob to move the paper up, guide the paper
over the lower paper guide and through the slot in the top cover. For
pedestal models with the Quick Access Cover, refer to the
Quick Setup
Guide
for paper exiting options.
25. Press
(PAPER ADVANCE) several times to make sure the paper
feeds properly beyond the tractors and over the lower paper guide. Feed
sufficient paper to ensure the paper stacks correctly.
26.
Cabinet models
:
Open the cabinet rear door. Make sure the paper is aligned with the label
in the output area (inside the cabinet). Close the front and rear doors.
Figure 14. Aligning the Perforation with the TOF Indicator
27. Align the top of the first print line with the TOF indicator on the tractor by
rotating the vertical position knob. For best print quality, set the top-of-
form at least 1/2 inch below the perforation.
NOTE:
For exact positioning, press the
(VIEW/EJECT) key to move the
last data printed to the tractor area for viewing. While in View mode
“Printer in View” displays. Press the Up or Down Arrow keys to move
the paper vertically in small increments. Pressing the
(VIEW/
EJECT) key a second time moves the paper back to the adjusted
print position. The key owrks both online and offline provided that the
printer is in View mode. (This procedure is applicable for both the
cabinet and pedestal models.)
TO
F
TOF
TOF
TO
F
183967a
TOF Indicator
Perforation
Vertical
Position
Knob