Printronix P7000 H-Series Cartridge Ribbon Printer - Manual (Page 32)

32
Chapter 3 Operational Procedures
Figure 15. Adjusting the Platen Lever
28. Turn the platen stop knob clockwise or counterclockwise to match the
paper thickness. (The A-B-C scale corresponds approximately to 1-, 3-,
and 6-part paper thickness. Adjust until you have the desired print
quality.)
NOTE: The platen stop allows you to set an optimum and consistent
thickness that is not affected when opening and closing the platen
lever.
29. Lower the platen lever until it stops.
30. Press ( ON LINE/CLEAR) to clear any fault messages (such as “LOAD
PAPER”) from the LCD.
31. Press ( SET TOF). The top-of-form you have set moves down to the
print position. If there is data in the buffer, the paper moves forward to the
last print position on the next page.
32. Press ( ON LINE/CLEAR) and close the printer cover.
183444 REV B
183444b
183446b
Platen Lever
Vertical Position
Knob
Platen Stop
Knob
A
Platen
Stop
183445b
Paper Thickness
Indicator
A