Printronix P7000 H-Series Cartridge Ribbon Printer - Manual (Page 136)

136
Chapter 7 Diagnosing Problems
411:PARITY ERROR Yes The printed output may
contain a random ?
(question mark) characters. Check your printer serial
interface parameter settings; if
necessary, adjust them so that
they match the settings of the
attached host.
414:RIBBON STALL Yes The controller board does
not detect ribbon movement. Check the ribbon path for jams.
Turn the Ribbon Tension Knob
clockwise a few rotations. If
necessary, install a new ribbon.
415:SHUTTLE JAM Yes No shuttle movement or
shuttle moving at the wrong
speed. Check for obstruction to shuttle,
a twisted ribbon, or platen lever
closed too tightly. If fault source
is not apparent, contact your
authorized service
representative. 1
416:STACKER FULL Yes Status message: the power
paper stacker is full of paper. Unload the stacker. If fault
persists, contact your authorized
service representative.
1
417:STACKER JAM Yes This message is triggered if
there is paper inside the
throat of the stacker
elevator, but the elevator is
not moving. 1. Open the cabinet rear door
and check for obstructions
preventing elevator movement.
Remove any obstructions.
2. Run the print job again. If the
message appears again, contact
your authorized service
representative. 1
418:RBN INK LOW
Change RBN Soon Yes Status message indicating
the Integrated Print
Management System is
enabled and ribbon ink level
is 2%. Install a new ribbon.
419:RBN INK OUT*
Install New RBN Yes Integrated Print
Management System
software has determined
that the ribbon is out of ink. Install a new ribbon.
420:EXC RBN WEAR
Install New RBN Yes Status message that
displays when ribbon
reaches end of life, whether
the Integrated Print
Management System is
enabled or not. Install a new ribbon.
Table 10. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution