Printronix P7000 H-Series Cartridge Ribbon Printer - Manual (Page 60)

60
Chapter 4 HOST INTERFACE
Reset Cfg Names
You can reset specific configuration names back to the default value of the
configuration number.
Auto Save
• Enable (default). When a change has been made to a configuration
menu, this option automatically prompts you to save or not save the
change to config #. If you are currently in the Factory Config. menus and
make a change, pressing Enter saves to Config 1 or the next available
config. and becomes the Power-Up config. If the current config is Config 1
and a menu change is made, pressing Enter will save the change to
Config 1.
• Disable . The printer will not prompt you to save any changes made.
HOST INTERFACE
The Host Interface Menu enables you to select and configure one of many
types of interfaces between the printer and your host computer. The currently
selected interface is indicated with an asterisk on the control panel message
display. Each interface has its own submenu with a set of interface
parameters which can be configured.
HOST
INTERFACE
(from page 52)
IEEE 1284 Auto
Switching*
Centronics Serial
Ethernet 1
(see page 74) (see page 61) (see page 63) (see page 68)
(see page 76)
* = Factory Default
1 Available when an Ethernet is present.
2 Available when an Adapter is present.
E-Net
Adapter 2
(see page 75)
Dataproducts
(see page 65)