EVS ENGSoft v1.5 User Guide - Manual (Page 57)

ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
57 / 63
You can also specify your own set of speeds for fast forward and rewind by replacing the default speeds or by adding or
removing different speeds to the speed lists. When you click on the and buttons of the player, the playback will
loop between these speeds.
Figure 108: Player configuration dialog
13.4 Player controls
The player module has a full set of playback commands. You can play forward or backward at any chosen speed; you can
cue frame by frame or seek to a given position manually or by timecode. You can also set in and out marks for the selected
sequence.
Figure 109: Player's controls
Figure 110: The upper bar shows the name of the video file currently being viewed in the player
The 'Play/Pause' button plays/pauses the video (Shortcut: Space bar).
The 'Stop' button stops the video while it is playing.
The 'Loop' button toggles the playback in loop mode. When the sequence reaches the end, the play
automatically restarts from the beginning.
The 'Go to Start/Go to End' buttons seeks to the start/end of the sequence.
The 'Fast Rewind/Fast Forward' buttons allows you to change the playback speed of the video.
Repeated clicks increase the speed. By default four speeds are available; a fifth click will loop back to
the initial speed.
i
Fast forward and fast rewind operations are not available on LongGop formats.
Enable the new In/Out timecode (the cut) for the video being played.