5 xdcam planning support, 1 overview, 2 enabling xdcam planning support in engsoft – EVS ENGSoft v1.5 User Guide User Manual
Page 25
ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
25 / 63
10.5 XDCAM Planning support
10.5.1 Overview
In addition to traditional clip metadata, the SONY XDCAM standard can provide a user-defined metadata set called the
plan-
ning metadata set. You can take advantage of this feature in ENGSoft by enabling the XDCAM planning support option.
When this option is activated you can browse, map and ingest planning information in ENGSoft like any other metadata set.
Only one user- defined planning set can be used by ENGSoft at a time. If you want to take advantage of your
XDCAM material planning metadata you should start by carefully defining the information you will need to access in your
planning metadata and design it. This set alone will be recognized as the valid planning set by ENGSoft. If you want us to
help you design the planning metadata that best fits your workflow needs, contact us at
.
10.5.2 Enabling XDCAM planning support in ENGSoft
An XML schema file will be designed for your specific needs and should be installed to complete the configuration of ENG-
Soft and enable XDCAM planning support.
After
you
install
the
application,
you
will
have
to
manually
copy
the
"XDCAMPlanningSchema.xsd"
file that has been provided with your software installer in the
"C:\ProgramData\OpenCube Technologies\OpenCube ENGSoft"
folder.
Figure 36: Location of the XDCAMPlanning schema to enable XDCAM planning support