EVS ENGSoft v1.5 User Guide - Manual (Page 46)

ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
46 / 63
Figure 81: Create connection by dragging a link between source and destination pin
You can disconnect all the pins of an audio layout by clicking on the button on top of the layout. You can reconnect all
the pins of an audio layout by clicking on the button on top of the layout.
Figure 82: Disconnect all the pins of the 4 audio layout Figure 83: Straight connect all the pins of the 4 audio layout
Saving an audio routing configuration
Each layout must be completely connected to create a valid configuration. The configuration must be valid in order to be
saved.
Figure 84: If any pin is disconnected, the configuration is invalid and saving is prohibited
The save buttons are highlighted when a configuration change should be saved.
Figure 85: A visual hint reminds you to save your changes
If you click on the [Save as...] button a popup will appear allowing you to choose the name of the configuration to save. An
interactive name validation feature prevents you from typing an invalid or duplicate configuration name.
Figure 86: The "Save configuration as..." dialog lets you choose the name of the configuration to save
Once saved, the configuration is appended to the available configuration list and may be used by any other destination sub-
ject. To assign a previously saved audio routing configuration to the current destination subject, simply select it in the "Cur-
rent routing configuration" combo box.