EVS ENGSoft v1.5 User Guide - Manual (Page 30)

ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
30 / 63
12.2 Destination list
The 'Unselect all' button clears all subject selections.
The 'New subject' button allows you to create a new destination subject by choosing from among the des-
tination types available.
The 'Delete subject' button is used to remove the subject selected from the destination list. The subject's files
and folders will not be deleted however.
The 'Rename subject' button allows you to change the subject name.
The 'Change subject folder' button allows you to browse a new location for the subject selected. The brows-
ing dialog type corresponds to the selected subject type.
The 'Subject options' button allows you to configure the subject selected. The configuration dialog type cor-
responds to the selected subject type.
The 'Auto Ingest' button lets you open the Auto-Ingest dialog. This action is available only if the source mod-
ule is in real mode.
The 'Ingest all' button allows you to send all the sequences displayed in the explorer to the ingest stack. A
subject must be selected to enable this action.
The 'Ingest selected' button allows you to send the sequences selected in the explorer to the ingest stack. A
subject and at least one sequence must be selected to enable this action.
The 'Consolidate all' button allows you to send all the sequences displayed in the explorer to the ingest stack
in order to consolidate them. A subject must be selected to enable this action.
The 'Consolidate selected' button allows you to send the sequences selected displayed in the explorer to the
ingest stack in order to consolidate them. A subject and at least two sequences must be selected to enable
this action.
To ingest sequences, you must first create a destination subject.
ê
Interplay and/or IPDirector must already be configured before you create an Interplay/IPDirector destination subject.
Figure 45: Creating a new destination subject
The following destination subject types are supported by ENGSoft v1.5: