EVS ENGSoft v1.5 User Guide - Manual (Page 44)

ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
44 / 63
Figure 75: Audio routing panel with a configured mapping
The audio configuration panel is divided in several zones:
l The top part contains the name of the current audio routing configuration. By default no configuration is set.
l The middle zone contains up to two audio layout graphs, each one corresponding to a possible ingest scenario,
four or eight audio. Each layout must be completely connected to make a valid configuration.
l
The bottom zone contains a summary of the status of the current configuration, a "Save" button to save the current
configuration and a "Save as..." button which allows you to choose the name of the configuration to save.
Default audio routing configuration
By default no routing is applied to the destination subject. A straight one to one mapping graph is applied: source pin #1 is
connected to destination pin #1, source pin #2 to destination pin #2, and so on.
Figure 76: Default audio mapping
Audio layout description
There are up to two audio layout graphs per audio configuration, each one corresponding to a possible ingest scenario:
four or eight audio.