EVS ENGSoft v1.5 User Guide - Manual (Page 26)

ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
26 / 63
11 Explorer Module
11.1 Overview
The sequences contained in all the selected sources are displayed in the explorer panel. You can customize the explorer
view in a number of different ways.
Figure 37: Explorer overview
There are various command buttons on top of the explorer panel:
The 'Select all' button selects all the displayed sequences.
The 'Unselect all' button clears the explorer selection.
The 'Refresh' button updates the icons and information of the displayed sequences.
The 'Icon/List/Detail view' toggle button allows you to switch between the three view modes.
Figure 38: The detail popup
i
You can configure the information you want to display in detail view in the explorer by
right-clicking on the header view bar and selecting the details you want. The set of details
you can display depends on the source device type.
The 'Clip name/User clip name' toggle button allows you to switch the name of the sequences
between the file name and the user-defined name.