EVS XSense Version 10.04 - January 2011 Configuration Manual - Manual (Page 56)

XSense – Version 10.04 – Configuration Manual
EVS Broadcast Equipment – January 2011
Issue
10.04.B
47
3.8.6 R
ESYNC TO
TC R
EF
The Multicam application uses an internal table to reference all timecode
discontinuities detected on the LTC input of the system. This table is used to
match a recorded field to its timecode. When the number of TC discontinuities is
too important, a “!TC” warning appears on the OSD of the output monitors and the
system switches to the “internal timecode mode. The operator can clear the TC
discontinuities by calling the Resync to TC ref function. This function
synchronizes the internal TC to the timecode read on the LTC input of the server.
From that moment on, the system will assume that the timecode was continuous
for previously recorded material, and will take into account the new timecode
discontinuities.
Note that the above explanation is only valid for record trains. For clips, the
timecode of the first field of the clip is memorized at the creation of the clip, and
the timecode is always assumed continuous inside the clip. Clearing the internal
TC table will consequently have no effect on the timecode of recorded clips.
To call the Resync to TC ref function, simply press the F6 key. The function is
immediately performed and the message “TC resynchronization done”
is displayed.
Record Trains p.2.2
[F1]Guardbands : 05s00fr
[F2]Default clip duration : 04s00fr
[F3]Mark cue points : Live
[F4]Preroll : 02s00fr
[F5]Record trains OUTs : Play Through
[F6]Freeze on cue points : No
[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn
3.8.7 G
UARDBANDS
Range: from 00s00fr to 60s00fr. Default: 05s00fr
This option specifies the amount of «guardband» before and after clips.
3.8.8 D
EFAULT
C
LIP
D
URATION
Possible values: Disable, or from 00s01fr to 4h. Default: 04s00fr
This option allows the user to set the duration of clips created with only IN point
or only OUT point. When set to “Disable”, both IN and OUT points are required to
be able to create a clip.
The duration can be set:
• With second granularity up to 1 minute
• With minute granularity from 1 minute up to 4 hours.