EVS XSense Version 10.04 - January 2011 Configuration Manual - Manual (Page 29)

Issue
10.04.B XSense – Version 10.04 – Configuration Manual
EVS Broadcast Equipment – January 2011
20
Setting Description
Play Initiates a play command at 100% on the
selected channel.
Pause Initiates a pause command on the selected
channel.
Recue Initiates a jump to the IN point of the on air
element on the selected channel.
If this is a playlist, the jump is performed to
the IN point of the first clip of the playlist.
Previous Initiates a command to go to the previous
clip of a playlist on the selected channel.
Next Initiates a command to go to the next clip of
a playlist on the selected channel.
Skip Initiates a command to skip the clip being
played on the selected channel.
Tally Activates or deactivates the on-air flag on
the selected channel. This GPI is only used
by IPDirector.
Mark IN Sets an IN point on the corresponding
recorder channel.
Mark OUT Sets an OUT point on the corresponding
recorder channel.
Mark Tly Sets IN and OUT points on record trains
based on changes in camera angles of the
director’s cut. An IN point is set on the train
to which the director switches and an OUT
point is set on the train that the director
leaves.
Exit ASP Initiates a command to exit the loop as soon
as possible without playing the current
element until its end and jump to the
selected element. This GPI is used with
playlists in IPDirector.
Exit OUT Initiates a command to exit the loop as soon
as the OUT point of the current element is
reached and jump to the selected element.
This GPI is used with playlists in IPDirector.
None No value is defined.