Garmin G1000 Piper PA-46 Meridian - Manual (Page 523)

190-00763-01 Rev. A Garmin G1000 Pilot’s Guide for the Piper PA-46 Meridian
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EICAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
509
APPENDIX A
Caution Messages Description
Inhibits
ESDI ESI GROUND TOPI AIR LOPI
PROP HEAT FAIL Propeller heat failure X X
STALL WARN FAIL Failure detected in stall warning system
STARTER ENGAGED Starter engaged when Ng is more than 56% for more than 10 sec. X X
STBY BAT HT FAIL Standby attitude battery heater failure X X
SURF DE-ICE FAIL Surface de-ice fail X X X X
VACUUM LOW Vacuum is low X X X X
* Only affected side (L, R) displayed in CAS message; noted CAS messages display L/R as an example.
ADVISORY MESSAGES
Advisory Messages Description
Inhibits
ESDI ESI GROUND TOPI AIR LOPI
ALTERNATOR OFF Alternator is off
BETA Propeller is operating in Beta mode
DOOR AJAR Door is ajar
EMER BLEED ON Emergency bleed is on
FEATHER Propeller is feathered
L/R* FUEL PUMP ON
Left or right fuel pump is on. Inhibited if fuel pump is on for fuel
autobalance when imbalance is less than 40 lbs.
FUEL TEMP Fuel temperature is low
GENERATOR OFF Generator is off
IGNITION ON Engine ignition is on
OXYGEN Oxygen system has been turned on X X
STARTER ENGAGED Starter engaged when Ng is less than 56% X X
STBY BAT TEST OK Standby attitude battery test pass (standby attitude indicator must be off)
* Only affected side (L, R) displayed in CAS message; noted CAS messages display L/R as an example.
The G1000 Alerting System conveys alerts using the following:
• Message Window: The Message Window displays text messages for up to 64 prioritized alert messages.
Pressing the MSG Softkey displays the Message Window. Pressing the MSG Softkey a second time removes
the Message Window from the display. When the Message Window is displayed, the FMS Knob can be used to
scroll through the alert message list.
• Softkey Annunciation: When a new message is issued, the MSG Softkey flashes to alert the flight crew of a
new message. It continues to flash until acknowledged by pressing the softkey. Active messages are displayed
in white text. Messages that have become inactive change to gray text. The
MSG Softkey flashes if the state of
a displayed message changes or a new message is displayed. The inactive messages can be removed from the
Message Window by pressing the flashing
MSG Softkey.