ZyXEL Communications 662HW Series - Manual (Page 552)

Prestige 662H/HW Series User’s Guide
Appendix S 552
Log Commands
Go to the command interpreter interface ( Appendix N explains how to access and use the
commands).
Configuring What You Want the Prestige to Log
1 Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the Prestige is to record.
2 Use sys logs category to view a list of the log categories.
Figure 41 Displaying Log Categories Example
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.
Figure 42 Displaying Log Parameters Example
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
SIG Signature
NONCE Nonce
NOTFY Notification
DEL Delete
VID Vendor ID
Table 47 RFC-2408 ISAKMP Payload Types (continued)
LOG DISPLAY PAYLOAD TYPE
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys exit device ether
wan poe aux config
wlan ip ipsec ppp
bridge hdap bm lan
radius 8021x
ras>
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both]
ras>