ZyXEL Communications 662HW Series - Manual (Page 125)

Prestige 662H/HW Series User’s Guide
125 Chapter 9 WAN Setup
Figure 43 Advanced Modem Setup
The following table describes the fields in this screen.
Table 29 Advanced Modem Setup
LABEL DESCRIPTION
AT Command
Strings
Dial Type the AT Command string to make a call. Example: atdt
Drop Type the AT Command string to drop a call. " ~ " represents a one second wait, for
example, " ~~+++~~ath " can be used if your modem has a slow response time.
Answer Type the AT Command string to answer a call. Example: ata
Drop DTR When
Hang Up
Select this check box to have the Prestige drop the DTR (Data Terminal Ready)
signal after the " AT Command String: Drop " is sent out.
AT Response
Strings
CLID Type the keyword that precedes the CLID (Calling Line Identification) in the AT
response string. This lets the Prestige capture the CLID in the AT response string
that comes from the WAN device. CLID is required for CLID authentication.
Example: NMBR
Called ID Type the keyword preceding the dialed number.
Speed Type the keyword preceding the connection speed. Example: CONNECT
Call Control
Dial Timeout Type a number of seconds for the Prestige to try to set up an outgoing call before
timing out (stopping). Example: 60
Retry Count Type a number of times for the Prestige to retry a busy or no-answer phone
number before blacklisting the number. Example: 0