ZyXEL Communications 662HW Series - Manual (Page 455)

Prestige 662H/HW Series User’s Guide
455 Chapter 48 Troubleshooting
48.3 Problems with the DSL LED
48.4 Problems with the LAN Interface
48.5 Problems with the WAN Interface
Table 157 Troubleshooting the DSL LED
PROBLEM CORRECTIVE ACTION
The DSL LED is
off.
Check the telephone wire and connections between the Prestige DSL port and the
wall jack.
Make sure that the telephone company has checked your phone line and set it up
for DSL service.
Reset your ADSL line to reinitialize your link to the DSLAM. For details, refer to the
Maintenance chapter (web configurator) or the System Information and Diagnosis
chapter (SMT).
Table 158 Troubleshooting the LAN Interface
PROBLEM CORRECTIVE ACTION
I cannot access the
Prestige from the
LAN.
If the 10M/100M LEDs on the front panel are both off, refer to the Problems
with the LAN LED section.
Make sure that the IP address and the subnet mask of the Prestige and your
computer(s) are on the same subnet.
I cannot ping any
computer on the LAN.
If the 10M/100M LEDs on the front panel are both off, refer to the Problems
with the LAN LED section.
Make sure that the IP address and the subnet mask of the Prestige and the
computers are on the same subnet.
Table 159 Troubleshooting the WAN Interface
PROBLEM CORRECTIVE ACTION
I cannot get a
WAN IP address
from the ISP.
The ISP provides the WAN IP address after authenticating you. Authentication
may be through the user name and password, the MAC address or the host name.
The username and password apply to PPPoE and PPPoA encapsulation only.
Make sure that you have entered the correct Service Type, User Name and
Password (be sure to use the correct casing). Refer to the WAN Setup chapter
(web configurator) or the Internet Access chapter (SMT).