Xerox 604P18057 - Manual (Page 39)

Power Saver Modes
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User Guide 39
Before using the machine, press the TEST button. If the GFI is working properly, the
RESET button should pop up. If it does, press the RESET button.
NOTE: If the RESET button pops back up when you press it, or if power is not
restored by this procedure, contact the Xerox Welcome Center.
Power Saver Modes
The machine has energy saving features that significantly reduce power consumption
during inactivity. The button is located on the upper-right portion of the
control panel, and lights up when the power saving feature is enabled. The power
saving feature operates in the following two modes.
• Low Power Mode
• Sleep Mode
Low Power Mode
The machine automatically switches to the Low Power Mode after a certain period of
time from the last copy, fax, scan, or print operation. In this mode, the touch screen is
turned off, and the Power Saver light is on. The Low Power Mode is cancelled when
the button on the control panel is pressed, or a fax or print job is
received by the machine. The factory default setting of 15 minutes is customer
changeable within the range of 2 to 60 minutes.
For more information, refer to Auto Power Saver in the Setups chapter on page 192.
RESET button
TEST button
light/button