Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 97)

Chapter 8
SpeedTouch™ Remote Access
E-DOC-CTC-20051017-0155 v1.0 87
Hyper-NAT Refinements The SpeedTouch™ features a powerful Hyper-NAT engine allowing the local hosts
to share a single (remotely negotiated) public IP address.
In case Hyper-NAT is enabled on the WAN interface that will be used for remote
management, and a static mapping has been made to allow remote hosts to
address regular HTTPs services on a host residing on your local network, you must
make sure that accessing the SpeedTouch™ Web Interface is still possible.
The default port for the HTTPs server is set to 443. This can be changed by
executing the following command:
The command above will change the HTTPs server port of the SpeedTouch™ from
port 443 (default) to port 448.
For more information on Hyper-NAT, see the SpeedTouch™ Hyper-NAT
Configuration Guide.
=>:service system modify name=HTTPs state=enabled port=448
=>
=>:service system list name=HTTPs expand=enabled
Idx Name Protocol SrcPort DstPort Group
-----------------------------------------------------------------------
1 HTTPs tcp 448
Description............... HTTP web server over ssl
Properties................ server
Attributes................ state port aclip aclif aclifgroup map log
User Managed Attributes... state port aclip aclif aclifgroup map log
Attribute Values :
State...................... enabled
Port....................... 448
Ip Access List............. any
Interface Access List...... any
Interface Group Access List lan wan
Map List................... 448
Logging.................... disabled
=>
!
NAT-refinements for SpeedTouch™ services should never be made in the
NAT configuration menu, but always in System Services.