Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 208)

Chapter 12
SLA Monitoring.
E-DOC-CTC-20051017-0155 v1.0 198
Now that we defined an SLA ping test we need to configure the test. The following
parameters can be configured:
Parameter Description Values
test The name of the traceroute
test to configure. string
addr The destination IP address. string
size The size of the data portion to
be transmitted in a traceroute
request. number{0-20000}
timeout The timeout value, in seconds,
for a traceroute request number{1-60}
probePerHop The number of times to
reissue a traceroute request
with the same time-to-live
value . number{1-10}
port The UDP destination port
number to send to. number{1-65535}
maxTtl The upper limit on the number
of routers through which a
packet can pass. number{1-255}
initTtl The initial time-to-live value. number{0-255}
createHopEntries Enables creation of traceroute
hop table. disabled or enabled
frequency The number of seconds to wait
before repeating a traceroute
test. number{0-65535}
maxrow The max number of entries in
the history table. number{0-100}
storagetype The storage type of this entry. volatile or
nonVolatile
trap The value determines when
and if to generate a
notification. [+/-]flag[+/-
flag...]{pathChange
testFailure
testCompletion}
type The implementation method to
be used for the traceroute test. IcmpEcho ro
UdpEcho
descr The descriptive name of the
traceroute test. quoted string
srcaddr Ip source address to be used. ip-address
intf Interface name. none, loop, ipsec0,
Internet, lan1,
wan1, dmz1, guest1