How to view the configuration, How to configure cwmp: syntax, Chapter 8 – Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 User Manual
Page 119
Chapter 8
SpeedTouch™ Remote Access
E-DOC-CTC-20051017-0155 v1.0
109
How to View the
Configuration
From the main prompt, use the following command to view the CWMP Parameters:
This results in the following type of output on the screen, providing an overview of
all parameters and their values:
Similarly, to view the CWMP Server configuration, enter the following command
sequence from the cwmp prompt:
How to Configure
CWMP:
Syntax
From the cwmp prompt, use the following command to configure the CWMP
parameters:
=>cwmp
=>[cwmp]config
State : disabled
Mode : full
Max Envelopes : 2
Session Timeout : 60
No Ip Timeout : 10
Connection Request Port : 51005
Periodic Inform : enabled
Periodic Inform Interval : 3600 s
Connection Request : disabled
Connection Request UserName :
Connection Request PassWord :
Connection Request Path :
Connection Request Authentication : none
Qos class : 12
Boot delay range between 0 and : 0 s
=>[cwmp]server
=>[cwmp server]config
config
[state = <{disabled|enabled}>]
[mode = <{read-only|full}>]
[periodicInform = <{disabled|enabled}>]
[periodicInfInt =
[noIpTimeout =
[connectionRequest = <{disabled|enabled}>]
[connectionReqPath =
[connectionReqUserName =
[connectionReqPsswd =
[connectionReqAuth = <{none|basic|digest}>]
[qos-class =