Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 120)

Chapter 8
SpeedTouch™ Remote Access
E-DOC-CTC-20051017-0155 v1.0 110
How to Configure
CWMP:
Parameter Descripion
The CLI command uses the following parameters:
Parameter Value Description
state enabled or
disabled Enable or disable the CWMP
daemon
mode read-only or full Set the operational mode of
the CWMP daemon to read-
only or full.
periodicInform enabled or
disabled Enable or disable CWMP
periodic inform
periodicInfInt number Set the interval between two
periodicInform messages in
seconds
sessionTimeout number Set the HTTP session-timeout
in seconds
noIpTimeout number Set the time (in seconds) the IP
may be 0 after uploading a
new config file
maxEnvelopes number Set the maximum number of
SOAP envelopes sent within
one http-message
connectionRequest enabled or
disabled Enable or disable CWMP
connection request
connectionReqPath text string Set the path where the cwmp
daemon can be reached
connectionReqUserName text string Set the username the ACS
must use to log in
connectionReqPsswd text string Set the password the ACS
must use to log in
connectionReqAuth none, basic or
digest Set the authentication type of
modem CWMP server for
asynchronous connects
qos-class number Set the quality of service class
for outgoing CWMP data
bootdelayrange number Set the delay on boot before
inform is sent