Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 155)

Chapter 10
SpeedTouch™ Monitoring
E-DOC-CTC-20051017-0155 v1.0 145
10.2.5 How to Configure the System contact, Name
and Location
Command You can set the System contact, System Name and the System Location in the MIB
II RFC1213. Use the following CLI command to do so:
Parameters This command has the following parameters:
config
[sysContact = ]
[sysName = ]
[sysLocation = ]
[traps <{disabled|enabled}>]
Parameter Value Description
sysContact System Contact
sysName System Name
sysLocation System Location
traps enable or disable Enable or disable the sending
of traps.