Configuration via cli commands, Chapter 8 – Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 User Manual
Page 95
Chapter 8
SpeedTouch™ Remote Access
E-DOC-CTC-20051017-0155 v1.0
85
Configuration via
CLI commands
To have HTTPs access via WAN, additional configuration of the HTTPs service is
needed.
Use the following CLI command to allow HTTPs access from the WAN to the
SpeedTouch™:
If you take a look at the HTTPs service configuration, you will see that the
wan
group is added to the Interface Access List:
=>:service system ifadd name=HTTPs group=wan
=>
=>:service system list name=HTTPs expand=enabled
Idx Name
Protocol
SrcPort
DstPort
Group
-----------------------------------------------------------------------
1 HTTPs
tcp
443
Description............... HTTP web server over ssl
Properties................ server
Attributes................ state port aclip aclif aclifgroup map log
User Managed Attributes... state port aclip aclif aclifgroup map log
Attribute Values :
State...................... enabled
Port....................... 443
Ip Access List............. any
Interface Access List...... any
Interface Group Access List lan
wan
Map List................... 443
Logging.................... disabled
=>