Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 157)

Chapter 10
SpeedTouch™ Monitoring
E-DOC-CTC-20051017-0155 v1.0 147
10.2.7 How to Configure the SNMP Target
About the SNMP Target The SNMP target is the destination for the SNMP traps, e.g an SNMP Manager. You
can add up to nine different SNMP manager destination addresses, using the
:snmp target add command.
Command Use the following command to add an SNMP target:
Parameters: The command has the following parameters:
add name = addr = [port = ]
[mask = ]
[timeout = ] [retries = ]
[maxpertime = ] [windowtime = ]
[taglist = ] [params = <{V1Params}>]
[storage = <{other|volatile|nonVolatile|permanent|readOnly}>]
[mms = ]
Parameter Value Description
name Name of this target.
addr IP address of the target
port Target port number.
Default : 162.
mask IP bitfield mask,
This is only applicable in case of
source address checking.
timeout SNMP expected maximum round
trip time (in hundredths seconds)
for communicating with the target
address.
retries Number of times the snmp entity
will attempt to retransmit an
inform when no response is
received.
maxpertime Maximum number of
notifications that can be sent
within a limited time base,
defined as window time.
windowtime Time base (in seconds) that limits
the number of notifications. A
window time of 0 deactivates the
trap rate limitation mechanism.