About tr-064, Configuration options, How to configure lac: syntax – Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 User Manual
Page 116: Chapter 8
Chapter 8
SpeedTouch™ Remote Access
E-DOC-CTC-20051017-0155 v1.0
106
8.7 LAN Based Auto-Configuration (LAC) Support
(TR-064)
About TR-064
The SpeedTouch™ supports the DSL Forum’s TR-064 Technical Report on LAN
Based Auto-Configuration. This provides the possibility to automatically configure
the SpeedTouch™ from a management application running on a PC on the
customer premises LAN. For more information, refer to the DSL Forum’s Technical
Report TR-064.
Architecture
The diagram below shows the architecture and protocol stack for TR-064 on the
SpeedTouch™:
Configuration Options
It is impossible to configure LAC via the Web interface. Only CLI commands can be
used.
How to Configure LAC:
Syntax
No configuration is needed for LAC. It simply needs to be enabled or disabled. From
the system prompt, use the following command:
User Input
PC Operating System
CPE Management App
XML-based DSP CPE Management
Service Provider
XML Configuration
SpeedTouch
CPE Software
HTTPMU
HTTPU
XML
SOAP
HTTP
SSL
UDP
Layer 2
TCP
IP
SSL
UDP
Layer 2
TCP
IP
HTTPMU HTTPU
XML
SOAP
HTTP
SSDP
SSDP
[system]=>config
tr64 = disabled | enabled
tr64auth = disabled | enabled