Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 85)

Chapter 7
The SpeedTouch™ File System
E-DOC-CTC-20051017-0155 v1.0 75
7 The SpeedTouch™ File System
Introduction The SpeedTouch™ file system exists of nonvolatile memory responsible for storing,
retrieving and maintaining the system software files, configuration profile files,
language-pack files, software activation keys, secure storage files, etc.
The file system of the SpeedTouch™ is accessible via the well known File Transfer
Protocol (FTP). This allows to backup and restore files present on the SpeedTouch™
file system. Moreover, via FTP's
quote site command you are able to use a
limited set of CLI commands from the FTP prompt.
Opening an FTP session
to the SpeedTouch™
Proceed as follows to open an FTP session to the SpeedTouch™ file system (the
example shows an ftp session opened from an MS Windows Command Prompt):
In its default firewall configuration, FTP access to the SpeedTouch™ file system is
restricted to access from the local network only.
File system structure The file system features a tiny multilevel directory structure with two nodes '/active'
and '/dl'.
The root directory is secured and contains two subdirectories ‘/active’ and ‘/dl’.
The ‘/active’ subdirectory contains the system software in execution. Other files
may be present to ensure the good operation of the device, or due to previous
system software upgrades.
The ‘/dl’ subdirectory is the directory where you can find a user.ini file, holding the
most recently saved SpeedTouch™ configuration. The ‘/dl’ subdirectory also
contains the passive (dormant) system software (in most cases the passive system
software will be the same as the active system software present the ‘/active’
subdirectory. Optionally, the ‘/dl’ subdirectory may contain software activation keys
for enabling SpeedTouch™ software modules, language pack files and template
files. Other files may be present as well to ensure the good operation of the device.
In the example above the default SpeedTouch™ IP address 192.168.1.254 is
assumed, however another IP address may be assigned to your
SpeedTouch™ device.
There may be a user.ini file present in the ‘/active’ subdirectory. However,
this user.ini only contains the saved configuration since the last software
switchover, and hence may be not up-to-date.