Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 93)

Chapter 8
SpeedTouch™ Remote Access
E-DOC-CTC-20051017-0155 v1.0 83
Hyper-NAT Refinements The SpeedTouch™ features a powerful Hyper-NAT engine allowing the local hosts
to share a single (remotely negotiated) public IP address.
In case Hyper-NAT is enabled on the WAN interface that will be used for remote
management, and a static mapping has been made to allow remote hosts to
address regular HTTP services on a host residing on your local network, you must
make sure that accessing the SpeedTouch™ Web Interface is still possible.
The default port for the HTTP server is set to 80. This can be changed by executing
the following command:
The command above will change the HTTP server port of the SpeedTouch™ from
port 80 (default) to port 82.
For more information on Hyper-NAT, see the SpeedTouch™ Hyper-NAT
Configuration Guide.
=>:service system modify name=HTTP state=enabled port=82
=>
=>:service system list name=HTTP expand=enabled
Idx Name Protocol SrcPort DstPort Group
-----------------------------------------------------------------------
1 HTTP tcp 82
Description................ HTTP web server
Properties................. server
Attributes................. state port aclip aclif aclifgroup map log
User Managed Attributes.... state port aclip aclif aclifgroup map log
Attribute Values :
State...................... enabled
Port....................... 82
Ip Access List............. any
Interface Access List...... any
Interface Group Access List lan
Map List................... 82
Logging.................... disabled
=>
!
NAT-refinements for SpeedTouch™ services should never be made in the
NAT configuration menu, but always in System Services.