Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 109)

Chapter 8
SpeedTouch™ Remote Access
E-DOC-CTC-20051017-0155 v1.0 99
Hyper-NAT Refinements The SpeedTouch™ features a powerful Hyper-NAT engine allowing the local hosts
to share a single (remotely negotiated) public IP address.
In case Hyper-NAT is enabled on the WAN interface that will be used for remote
management, and a static mapping has been made to allow remote hosts to
address regular FTP services on a host residing on your local network, you must
make sure that accessing the SpeedTouch™ FTP server is still possible.
The default port for the FTP server is set to 21. This can be changed by executing the
following command:
The command above will change the FTP server port of the SpeedTouch™ from port
21 (default) to port 26.
For more information on Hyper-NAT, see the SpeedTouch™ Hyper-NAT
Configuration Guide.
=>:service system modify name=FTP state=enabled port=26
=>:service system list name=FTP expand=enabled
Idx Name Protocol SrcPort DstPort Group
-------------------------------------------------------------------
1 FTP tcp 26
Description................ File Transfer
Properties................. server
Attributes................. state port aclip aclif aclifgroup map log
User Managed Attributes.... state port aclip aclif aclifgroup map log
Attribute Values :
State...................... enabled
Port....................... 26
Ip Access List............. any
Interface Access List...... any
Interface Group Access List lan
Map List................... 26
Logging.................... disabled