5 remote ftp access, Introduction, Default http service configuration – Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 User Manual

Page 107: Configuration via cli commands, Remote ftp access, Chapter 8

Chapter 8

SpeedTouch™ Remote Access

E-DOC-CTC-20051017-0155 v1.0

8.5 Remote FTP Access

Introduction

The SpeedTouch™ FTP interface is provided by the SpeedTouch™ FTP server.
Access to this server and hence the FTP interface is controlled by the SpeedTouch™
FTP service. By default, the FTP service is configured to let the SpeedTouch™ FTP
server accept FTP requests from LAN side only. In addition the SpeedTouch™
provides FTP over SSH.

FTP over SSH provides a more secure way of accessing the SpeedTouch™ FTP
service and should therefore be used.

Default HTTP

service configuration

Use the following CLI command to see the default FTP service configuration.

Configuration via

CLI commands

To have FTP access via WAN, additional configuration of the SpeedTouch™ FTP
service is needed.

Use the following CLI command to allow WAN FTP access to the SpeedTouch™ via
CLI commands.

Use the following CLI command to look at the FTP service configuration, we notice
that the

wan

group is added to the Interface Access List:

The added rules will allow any user on the WAN to open an FTP session to the
SpeedTouch™ and access the file system after authentication.

=>:service system list name=FTP expand=enabled

Idx Name

Protocol

SrcPort

DstPort

Group

State

--------------------------------------------------------------------

1 FTP

tcp

enabled

Description................ File Transfer

Properties................. server

Managed parameters......... state port acl map log

Interface Access List...... lan

Ip Access List............. any

NAT Port List.............. 21

=>:service system ifadd name=FTP group=wan