Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 213)

Chapter 13
Resetting the SpeedTouch™
E-DOC-CTC-20051017-0155 v1.0 203
13 Resetting the SpeedTouch™
Introduction If needed you can reset the SpeedTouch™ to factory defaults or just reboot.
Normal reboot To reboot the SpeedTouch™ without erasing the current configuration,use the
following command:
This command will save the current configuration to the user.ini file.
Now enter the following command:
This command will reboot the SpeedTouch™ and will load the user.ini file upon
reboot so the previous saved configuration will be restored.
Reset to factory
defaults
To reset the SpeedTouch™ to factory defaults, usethe following command:
This command will delete the user.ini file (if the previous configuration was saved)
and reboots the SpeedTouch™.
If there is an isp.def file present in the ‘dl directory it will load this file. The isp.def
contains an Internet Service Provider specific configuration.
If no ips.def file is present on the device the SpeedTouch™ will reboot with the
hardware defaults.
=>:saveall
=>:system reboot
=>:system reset factory=yes proceed=yes