Adsl and shdsl mibs, Ilmi mibs, Atm mibs – Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 User Manual
Page 148: Chapter 10
Chapter 10
SpeedTouch™ Monitoring
E-DOC-CTC-20051017-0155 v1.0
138
ADSL and SHDSL MIBs
Following two MIBs are specific per SpeedTouch™’s DSL variant (ADSL or SHDSL
variants). You should only load the appropriate MIB, although loading both will not
harm functionality. To retrieve maximum SNMP information it is imperative to use
the MIB provided on the SpeedTouch™ Setup CD, and not the one supported (if so)
by the SNMP manager.
RFC2662 ADSL MIB (containing ADSL-LINE-MIB and ADSL-TC-MIB)
The ADSL MIB is in fact a bundle of three MIBs: the ADSL-LINE-MIB, the ADSL
TC- MIB and additionally the PerfHist-TC-MIB. It contains management
information about the ADSL line such as Signal-to-Noise Ratio (SNR), output
power and attainable bit rate. For using the RFC2662 ADSL MIB, the PerfHist-
TC-MIB is required, available on the SpeedTouch™ Setup CD.
RFC3276 SHDSL MIB
The SHDSL MIB contains management information about the SHDSL line such
as Signal-to-Noise Ratio (SNR), Loop attenuation, PSD regional setting, line
rate and line status.
ILMI MIBs
The SpeedTouch™ supports the following ILMI MIBs:
af-ilmi-065.000
fb-nm-0122
fb-nm-0165
ATM MIBs
Following MIBs are specific for the SpeedTouch™ ATM interfaces:
RFC2515 ATM MIB
This is the MIB Module for ATM and AAL5-related objects for managing ATM
interfaces, ATM virtual links, ATM cross-connects, AAL5 entities, and AAL5
connections.
RFC2514 ATM-TC-MIB
This MIB Module provides Textual Conventions and OBJECT-IDENTITY
Objects to be used by ATM systems.