Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 50)

Chapter 4
SpeedTouch™ Configuration Management
E-DOC-CTC-20051017-0155 v1.0 40
4.4 SpeedTouch™ Service Templates
Introduction Template files are ASCII text files consisting of a set of SpeedTouch™ (embedded)
Easy Setup wizard specific commands and CLI commands.
Used by the SpeedTouch™ (embedded) Easy Setup wizard, template files allow
users to complete the configuration of the device in a convenient and
comprehensive way, without the need of manual configuration via CLI or the Web
Interface.
Delivered template files Three template files are by default delivered within the SpeedTouch™ System
software for use by means of the embedded Easy Setup wizard:
Template files on the
SpeedTouch™ file
system
As the default templates, are embedded in the system software, these template files
will not be present in the ‘/dl’, (or ‘/active’) subdirectories by default.
However, via FTP access you are able to upload additional template files from the
SpeedTouch™ Setup CD, or custom template files to the SpeedTouch™ ‘/dl’
subdirectory, to extend the diversity of embedded configuration possibilities and/or
to avoid the need of using the SpeedTouch™ Home Install Wizard from the CD.
Template Description
Bridge A template to configure the SpeedTouch™ for Bridged Ethernet
WAN access (actually as an IEEE802.1D Transparent Bridge). In
this template, the DHCP Server has been disabled.
Router A template to configure the SpeedTouch™ for Routed PPPoE or
PPPoA. For the local network the SpeedTouch™ acts as DHCP
server.
Routed IPoA A template to configure the SpeedTouch™ for Routed IP over
ATM. For the local network the SpeedTouch™ acts as DHCP
server.
Each time the SpeedTouch™ Home Install Wizard is used to configure the
device a ‘backup’ user.tpl file is created/overwritten in the ‘/dl’ subdirectory,
for future use by the embedded Easy Setup wizard.