Ricoh FAX4500L - Manual (Page 84)

Switch 03 - Automatic printing of reports
Digit Purpose
0
Inclusion of part of the image on the following reports: Transmission Result Report,
Memory Storage Report, Polling Clear Report, Communication Failure Report,
Transfer Result Report, Transmission Deadline Report, Polling Confirmation List
0: No
1: Yes
1 to 7 Do not change these settings.
Switch 04 - Various
Digit Purpose
0, 1 Do not change these settings.
2 Automatic reduction 0: Off 1: On
3, 4 Do not change these settings.
5 Restricted Access 0: Off 1: On
6 Do not change this setting
7
Ordering Toner 0: Disabled 1: Enabled
If this is set to 1, store your dealer’s fax number in Quick Dial Key 32. Then, when
you need to order toner, use the procedure on page 62.
If you wish to use Quick Dial 32 for a number other than that of your dealer, set this
bit to 0. Quick Dial Key 32 can now be programmed in the same way as other Quick
Dial Keys. However, you will not be able to use the Ordering Toner feature.
Switch 05 - Various
Digit Purpose
0 Substitute reception 0: Off 1: On
1
Multi-sort document reception with reverse order printing (Memory card or hard disk
required)
0: Off 1: On
2 Do not change this setting
3 Memory reception if no RTI or CSI received 0: Possible 1: Not possible
4 to 7 Do not change these settings.
2-3. Economy Transmission Time
1. Function 6 0 2 2 2 2
7 4
2. Input the time that you always wish Economy Transmissions to start.
❐ To change from AM to PM and vice versa, press * or #
3. Press Yes Function when the display is correct.
ECONOMY TX
TIME=
11 :00AM
YES TO END
SECTION 4. PROGRAMMING THE MACHINE
74