Ricoh FAX4500L User Manual
Page 141
Transmission Procedure
The following example shows how to dial (assuming that the ISDN Option Type
40 has been installed). The differences between this procedure and the procedure
for the base machine (refer to page 20) are as follows:
❐ You have to select G3 or G4 before you dial a number.
❐ You may have to input a subaddress for a G4 number if the destination has one.
1. Make sure that the machine is in
standby mode.
2. Carefully place the document into the
auto document feeder (not more than 50
pages).
3. Change the line type (G3/G4) to the cor -
rect setting by pressing the G4/G3 Se -
lector key on the operation panel.
4. Dial.
G3 numbers - If your machine is behind a PBX, include the PBX access code and a pause
before the number. For an international number, place a pause after the country code.
G4 numbers - If you wish to enter a subaddress, press the User Function Key that you have
already programmed as the subaddress key (code 16). Then enter the subaddress. (See page
56 for how to program a User Function Key.)
5. Yes
6. Either:
❐ Dial more numbers: go to step 4.
❐ Start the transmission: Start
Note:
If the other party has not had a G4 Terminal ID programmed, you will see
"
_
=" on the screen during transmission, instead of their ID.
MEMORY TRANS APR. 4. 12:25PM
SET DOCUMENT
MEMORY 100%
MEMORY TRANS OPTIONS
ENTER FAX NUMBER
MEMORY TRANS OPTIONS
ENTER FAX NUMBER
MEMORY TRANS OPTIONS
PRESS
YES
OR
CLR
.
NO
7005611234
_
MEMORY TRANS OPTIONS
ENTER NO. OR
START
DEST: 2
_
See page 20 for how to dial.
You may use Speed Dial,
Quick Dial, or the ten-key
pad.
APPENDIX C. ISDN OPTION TYPE 40
C-3