Ricoh FAX4500L - Manual (Page 56)

KEEPING THE HEATER ON ALL DAY: Set both timers to ON = 12:00AM.
KEEPING THE HEATER OFF ALL DAY: Set both timers to OFF = 12:00AM.
4. Either:
❐ Program the timer for another day: Go back to step 2.
❐ Finish: Yes Function
NOTE: For the Night Timer to take effect, you must switch it on. See page 71
for how to do this.
To print the received messages while the heater is off, press any key.
After all the messages have been printed, the heater will stay on for 5
minutes before switching off again. Because of this, the Night Timer
does not give you complete security for received documents.
2-4. Forwarding (Memory Card or Hard Disk Required)
This section shows you how to set up your machine to forward incoming fax mes -
sages to another location or locations. After you have done this procedure, you
must switch Forwarding on for it to take effect; see page 71 for how to do this.
1. Function 6 0 2 2 2 2
7 5
Note: At this time, you can print a For -
warding List by pressing
→
Start .
2. Input a two-digit code from 01 to 05 for a
forwarding station number. (This is the
number that you wish to direct incoming
messages to.)
Example: 0 2
3. Yes
FORWARDING SET FORWARD CODE
No. PRINT LIST
NO TO CANCEL
_
FORWARDING YES OR NO
No. 02 DEST. 0
DEST.0 on the opposite display shows that
there are no RTIs/CSIs stored so far for this
forwarding station.
FORWARDING ENTER FAX NUMBER
No. 02
NO TO CANCEL
_
SECTION 3. ADVANCED FEATURES
46