Parker Hannifin 88-021610-01G - Manual (Page 37)

Parker Hannifin
Chapter 3 Electrical Installation 37
To operate the Aries drive with separate control and motor AC input, remove
the factory installed external jumpers. With the jumpers installed, apply
power to the motor power mains only. Figure 12 shows the location of the
factory installed jumpers.
Figure 12 AR-20xE to AR-30xE Factory Installed Jumpers
Connector Locations
All Aries drive models have identical DRIVE I / O and Motor Feedback
connectors. However, the connectors for motor and control power, on the
AR-20xE and AR-30xE differ from the other models due to their higher power
capacity. The two power connectors on models AR-01xx through AR-13xx
are removable. The two power connectors on Models AR-20xE and AR-30xE
are non-removable. Descriptions of individual connectors and their
specifications follow in this chapter. See “Connector Descriptions,” and in
“Appendix A Additional Specifications.”
Figure 13 shows the names and location of the connectors on Aries drive
models AR-01xx through AR-13xx. Figure 14 shows them on the higher-
power models AR-20xE and AR-30xE.