Parker Hannifin 88-021610-01G - Manual (Page 105)

Parker Hannifin
Chapter 6 Command Reference 105
DMTAMB Motor Ambient Temperature
Type Motor Product Rev
Syntax DMTAMB Aries 1.0
Units r = Degrees Celsius
Range -5Ш.ШШ to 25Ш.ШШ : ±Ш.Ш1
Default 4Ш.Ш
Response DMTAMB: <*>4Ш.Ш
See Also DMTMAX , DMTRWC , DMTTCM , DMTTCW
The DMTAMB command sets the motor ambient temperature used by the
software motor thermal model. The DMTAMB value, in conjunction with the
motor thermal time constant (DMTTCM), the motor winding time constant
(DMTTCW), the motor thermal resistance (DMTRWC) and the continuous motor
current (DMTIC), is used in a real-time estimation of the motor winding
temperature. When the winding temperature exceeds DMTMAX, the drive
faults and reports E35–Motor Thermal Fault.
DMTD Motor Damping
Type Motor Product Rev
Syntax DMTD (does not take effect until RESET or
cycle power) Aries 2.0
Units Rotary motor: r = uNm/rad/sec
Linear motor: r = N/meter/sec
Range Rotary motor: Ш.ШШШШШШ to 1ШШШШ : ±1
Linear motor: DMEPIT (electrical pitch) dependent
Default Ш.ШШШШШШ
Response DMTD: *DMTD2ØØ
See Also DMTR
Note: This command does not take effect until you cycle power to the drive,
or send the RESET command.
Auto-Setup : When using a Parker motor and the Aries Support Tool, this
command is automatically set for the selected motor.
If you did not use the Aries Support Tool, are using non-Parker motors, or
sent an RFS command to the drive, the parameter is set to zero (0)—you
must manually set this parameter to a non-zero number.
For a list of auto-configured commands, see
DMTR .
The DMTD command specifies the damping of the motor itself. This includes
both magnetic losses and bearing losses.