Parker Hannifin Dynaserv G2 - Manual (Page 56)

5-2
Functions
5
5.1 Parameters and Monitors
The group of variables expressed by #*** is called parameters and monitors. Parameters/monitors are
classified according to their numbers as follows.
Parameter No. Parameter type Backup Comments
0 to 199 General parameters Stored Always possible to read and write.
200 to 299
Mechanical setting
parameters
Stored
Reading is always possible, but writing is possible only
when operating in mechanical setting mode.
300 to 399 Monitors -
Read only. Reading is always possible, but writing is not
possible at any time.
By expressing all parameters/monitors by #***, their values can be referenced (read). It is also possible to
change (write) the values within the range allowed for each parameter/monitor.
5.1.1 General Parameters
These parameters can be read and written at all times and an operational meaning is assigned to each. The details
of each parameter will be explained separately.
Note that these parameters are stored in the driver; they will not be deleted even if the power is turned off.
5.1.2 Mechanical Setting Parameters
It is always possible to read these parameters, but writing is possible only when operating in mechanical setting
mode. These parameters are set only once when the device is started up. An operational meaning is assigned to
each. The details of each parameter will be explained separately.
Note that these parameters are stored in the driver; they will not be deleted even if the power is turned off.
Note: If these parameters are changed during execution in mechanical setting mode, the changes made to the
values will not be reflected until the power is turned on again. Therefore, please note that if you try to read a
parameter value after you change the parameter, the value before the change is read until you turn the
power off and on again.
5.1.3 Monitors
These variables are used to display the driver's status. Only reading is allowed at all times and each has an
operational meaning. The details of each parameter will be explained separately.