Parker Hannifin Dynaserv G2 - Manual (Page 108)

8-16
DrvGII PC Utility
8
8.4.3 Oscilloscope
The oscilloscope displays time-series of parameter/monitor values.
Click “Oscilloscope (O)” under “MainMenu” to display the “Oscilloscope” dialog box.
Note: The parameter/monitor information is obtained automatically from the driver when the “Oscilloscope” dialog
is started. Please wait for a while until it becomes ready for use. (This operation is required only once for the
initial use.)
Figure 8.18 “Oscilloscope” dialog box
12) Vertical axis range
selection
12) Auto
Simplified terminal
12) Vertical axis range
selection
13) Data save
13) Data load